View and Download Hach Sc E instrument manual online. Analysis System. Sc E Measuring Instruments pdf manual download. Hach Sc Controller User Manual – Download as PDF File .pdf), Text File .txt) or read online. Hach Sc Controller User Manual . Hach Company, – .. 37 W with 25 W sensor/network card load 24 VDCpowered sc model: 24 VDC.
|Published (Last):||21 April 2011|
|PDF File Size:||18.60 Mb|
|ePub File Size:||8.5 Mb|
|Price:||Free* [*Free Regsitration Required]|
Pay attention to all danger and caution statements.
Hach-Lange SC User Manual | 58 pages
Section 11 Limited Warranty In the event that a defect is discovered during the warranty period, Hach Company agrees that, at its option, it will repair or replace the defective product or refund the purchase price, subject to the pro-rated schedule above, excluding original shipping and handling charges. The calibration history log shows the gain value, the time and date of the calibration, and the initials of the operator performing verification.
Relay loads must be resistive.
The following two options are available: Tug gently to check the connection. Warranty, liability and complaints 7. Mounting foot for panel mounting 2Cat. Wear cotton gloves to protect your hands and to avoid fingerprints on the bulb. Remove the quick connect fitting and wires and install the threaded plug on the opening to maintain the environmental rating.
HACH SC E INSTRUMENT MANUAL Pdf Download.
Wire as shown in Table 5. Do not touch the new bulb with bare hands. Operation During calibration, analog maunal can remain active, held, or transferred to a preset mA value.
Pipe vertical or horizontal 5. Mounting Foot 2Cat.
What’s missing? Tell us about it.
Section 1 Specifications Specifications are subject to change without notice. Index Numerics 90 Degree Detector Page 26 Installation 3. Manuql of Contents Section 1 Specifications The frequency will depend on the nature and concentration of dissolved and suspended solids in the sample. Section 7 Troubleshooting Section 7 Troubleshooting 7.
Maximum cable length is 9. Hex nut, M6 4Cat.
Hach-Lange SC 100 User Manual
This is the default setting. Hex nut 4Cat. Customize the outputs using the table in section 4. Controller Display Hacg Operation 4. Installation Electrical Installation High-voltage wiring for the controller is conducted behind the high voltage DANGER The instrument must be installed barrier in the controller enclosure.
Pass the cable through conduit and a conduit hub or a strain relief fitting and an available access hole in the controller enclosure. Table of Contents Section 5 System Startup Pay attention to all danger and caution statements.
If a service contract is taken out within 6 months of purchase, the warranty period is extended to 60 months. The controller display shows the current reading plus a secondary measurement such as temperature if connected to a single sensor, or two readings with their corresponding secondary measurement readings when two sensors are connected.
For the features available for each individual digital network port, refer to the instruction sheet supplied with the selected network card. Follow the appropriate wiring instructions per the purchased model. Theory Of Operation General Information 2.